The Formula 1 Spot Welder Powerful and intelligent 3-phase spot welder.
Fulfils the car manufacturers’ demands
on performance.
Support Arm and Tool Panel:
Totally flexible
Te smart support arm follows you wherever you place the
spot gun (optional).
A tool panel for easy access (optional).
4
cable system Two
sided spot welding Single
sided welding Spot
hammer welding Nuts
and bolts welding Carbon
shrinking Contact
shrinking Moulding
clip rivet welding Stich
welding
Single and
two sided welding CR100 delivers extreme welding
power with single sided welding
Easy to select
welding program and features
The digital display shows the selected program. A voice
message will appear to inform if the spot is ok or not.
Two sided
features:
Extension yokes Allows access to hard to reach
areas. Different sizes are available. Shown above,
the 600mm yoke (optional)
Easy yoke switching Switching electrode yokes is
easy with the CR100!
Loosen the handle and pull out the
C-yoke.
Slide desired extension
yoke into position.
Tighten the handle.
Smart and Easy C-Tong
A wide 6-8" (150-200 mm)
gap, allows access to hard
to reach areas. Just loosen
the lever and pull the elec-trode
holder out to widen the gap.
Single sided
features:
Stitch welding
Moulding clip rivet
welding
Bolt welding
TECNICAL DATA
Input voltage:
208-240V 50-60Hz 60A or
400V 50Hz 32A 3-phase AC
Degrees of protection:
IP 23
Welding amperage on the tips:
> 9500A DC
Nominal power:
> 19kVA
Duty cycle:
2.5%
Output voltage DC:
15V=
Cable length to the electrodes:
2.6 m incl. tong
Electrode Pressure:
At 7 bars (90 PSI)-280 daN (616 Lb)
Cooling system:
Air (2 fans) (with overheat warning)
Welding cable cooling:
Air cooling (with overheat warning)
Extension yoke system:
Up to 330mm reach (600mm optional)
Micro processor program:
6 menus (including “AUTO mode”
and welding quality verification)
4
cable system
